5 Series 504W11
Get Started Today!
How Much Can You Save?
5 Series 504W11
16.1 EER / 3.3 COP
Ultra Efficient Hot Water Generation - up to 6 tons
The 5 Series represents some of our best features and efficiencies. Its advanced components offer a level of comfort and savings that’s far greater than any ordinary system and among the geothermal industry’s highest. The 504W11 high temperature hydronic heat pump with OptiHeat technology is our geothermal solution for boiler replacement. Capable of delivering up to 150°F leaving hot water, this system is perfect for baseboard radiator systems, underfloor radiant applications, overfloor radiant applications, and fan coils. Typical geothermal hydronic systems are limited to water temperatures around 130°F which can make replacing fossil fuel boilers difficult. This system has been designed specifically to meet these higher temperature requirements and makes upgrading to a WaterFurnace system easier. It utilizes an additional heat exchanger to divert excess heat and reinjects it into the system, creating higher exiting water temperatures and optimum compressor operating conditions. Smaller loads are required and result in the ultimate in efficiency. Every unit is computer run-tested to ensure flawless performance at start-up – and in the unlikely event of a malfunction, they’re backed by the best warranties in the industry. Choose a geothermal system that’s Smarter from the Ground Up.
About First Geothermal Energy
Experience matters!! Perhaps the most important aspect of deciding upon a geothermal system installation is selecting a Geothermal installer. First Geothermal Energy is owned and operated by Mike Roberts. Mike has over twenty five years experience in the HVAC industry. Approximately fifteen Years ago he decided the future was geothermal, he has dedicated his geothermal career to the design and installation of a proper geothermal heat pump system for his customers. This starts with a complete evaluation of the current or future home or building. This includes measurements of the home;level of insulation; window and door sizes and grade; home exposure direction ect. All of this is done to determine the structures heat loss and heat gain. Once this is accurately calculated, a properly sized system, including the tonnage required and the size and design of the loop system is created.
Mike is a factory trained technician in geothermal design and installation, using the latest software and analytical data.
Licenced with the State of Ohio in HVAC and Plumbing Licence # 14124
Certified in refrigerant usage.
Certified in fusion welding techniques for the loop piping
